RS485 TO WIFI ETH MQTT
Software Preparation
Hardware Preparation
Log In To The Configuration Page
Open the wireless network connection and search for the network. The "Waveshare- AP" (xxxx is the last four digits of the MAC address) as shown in the figure below is the default network name of Service Set Identifier (SSID).
Enter the address in the computer browser: "10. 10.100 254"; the management page of RS485 TO WIFI/ETH will appear on the webpage -> Enter the user name and password with "admin".
If your browser fails to connect after entering"10. 10.100.254", you can use the following IP address:"10.10.100.222".
Connect To The Internet WAN
Please enable STA mode, as shown below:
Connect to the WiFi hotspot for Internet access (you can also open the network port and connect the network cable to the Internet)
STA mode has the same function as an external network cable. Please turn on WiFi and turn off the hotspot.
Easy-to-use Online MQTT Client|Try Now (emqx.io)
Enter the MQTT Setting to configure:
Communicate via MQTT and EMQX MQTT platform:
Tips: STA and ETH cannot be opened at the same time.