Details
STLINK-V3SET, modular in-circuit debugger and programmer for STM32/STM8
STLINK-V3SET Debugger/Programmer
Suitable for STM8 / STM32 microcontrollers
The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.
Features at a glance
- Stand-alone probe with modular extensions
- Self-powered through a Micro-B USB connector (does not provide power supply to the target application)
- USB 2.0 high-speed compatible interface
- Direct firmware update (DFU) support, to use with more future devices
- Supports JTAG / SWD interfaces, 3V~3.6V application voltage support and 5 V tolerant inputs
- Supports SWIM interface, 1.65V~5.5V application voltage support, only available with adapter board MB1440
- Virtual COM port (VCP) specific features:
- 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
- VCP frequency up to 15 MHz
- Available on STDC14 debug connector (not available on MIPI10)
- Drag-and-drop Flash programming
- Two color LEDs: communication, power
Software Support
Hardware Support
All STM32 MCUs with JTAG / SWD interface
All STM8 MCUs with SWIM interface
- for reference only, the STM32 and STM8 boards above are NOT included
- JP4 and JP6 jumper caps must be connected to use the SWIM interface
Product assembly diagram
STLINK Series Selection Guide
| Item | V3MINIE | V3SET | V2 |
|---|---|---|---|
| JTAG/SWD application voltage | 1.65V~3.6V① | 3V~3.6V | 1.65V~3.6V① |
| SWIM application voltage | N/A | 1.65V~5.5V | 1.65V~5.5V |
| SWV support | YES② | ||
| Debug interface | multi | multi③ | 2 |
| LED Indicator | two colors④ | ||
| ① ST-LINK/V2 and STLINK-V3MINIE support STM32 low-power devices. ② Only available for STM32 at present. ③ STLINK-V3SET features GPIO port besides the programming port. ④ Two colors LED indicates both power and communication. |
|||
What's On Board
- Micro USB port
- Power LED indicator
- COM LED indicator
COM LED is blinking RED: the first USB enumeration with the PC is taking place.
COM LED is RED: communication between STLINK-V3SET and the PC is established (end of enumeration).
COM LED is blinking GREEN/RED: data are being exchanged between the target and the PC. - UART header (VCP)
- SWIM header
- SWD header
- SWIM ON/OFF
enabled when jumper cap is connected - CAN header
- CAN ON/OFF
enabled when jumper cap is connected - UART Bridge
- SPI/UART/I2C/CAN/GPIOs Bridge
- SPI Bridge
- JTAG20 header
- STDC14 header
Product show
Outline dimensions
Weight: 0.23 kg
Quick Overview
STLINK-V3SET x1
